1. Take Adapt-a-Stop® brackets from packaging and align them at the desired location on the pallet rack upright or horizontal beam. 
  2. Secure bracket to beam:
    • For horizontal load stops, using provided nuts, bolts, and washers, or your own separately purchased nuts, bolts and washers (minimum 3/8” size), secure brackets to upright beams. Align holes in bracket with holes on upright beam.  Use the pre-drilled holes on the upright beam and the pre-drilled holes found on the bracket.  Apply between 20-40lbs torque pressure to secure the bracket to the upright beam.
    • For vertical load stops, using provided nuts, bolts, and washers, or your own separately purchased nuts, bolts and washers (minimum 3/8” size), secure bracket to the horizontal beam by using the pre-drilled holes found on the bottom of bracket.  Apply between 20-40lbs torque pressure to secure the bracket to the horizontal beam.
  3. Secure beam to brackets:
    • For horizontal load stops, clip a horizontal beam (not supplied by Adapt-a-Stop) onto the back of the Adapt-a-Stop® brackets. Ensure the beam’s locking safety pin is properly engaged. Then secure nuts, bolts and washers (minimum 3/8” size) on lower bolt hole on load bar. Apply between 20-40lbs torque pressure to secure the horizontal beam to the Adapt-a-Stop® brackets.  This ensures the load bar will remain attached to the Adapt-a-Stop® bracket in case the locking pin on the load stop beam fails.
    • For vertical load stops, using provided nuts, bolts, and washers, or your own separately purchased nuts, bolts and washers (minimum 3/8” size), secure Adapt-a-Stop® vertical bracket to a vertical beam (not supplied by Adapt-a-Stop) by using the pre-drilled holes found on the side of bracket aligned with the pre-drilled holes on the vertical beam.  Apply between 20-40lbs torque pressure to secure the bracket to the vertical beam.

 

Adapt-a-Stop does not accept returns of product due to shipping damage. In the event product is damaged during shipment, the customer must note with the shipping carrier that the item arrived damaged and contact Adapt-a-Stop within 72 hours of receipt.

 

Adapt-a-Stop warrants, to the extent and subject to the limitations described in this paragraph, that all Adapt-a-Stop products sold with the lifetime warranty to be free from defects in material and workmanship if properly installed, serviced, and operated under normal conditions according to Adapt-a-Stop instructions. Adapt-a-Stop’s obligation under this Warranty is limited to correcting or replacing, at its option, any equipment or parts that shall be returned to Adapt-a-Stop, transportation prepaid by customer, after being put into service by the original user, if Adapt-a-Stop is satisfied that the equipment was originally defective.

 

 

Adapt-a-Stop

P.O. Box 688

San Carlos, CA 94070

1-510-209-5134